Filter
Top Products
4-1
INSTALLATION OF OPTIONAL EQUIPMENT
4.1 Gyro Converter GC-8
The Gyro Converter GC-8, incorporated inside the radar display unit, converts
analog gyrocompass reading into digital coded bearing data for display on the
radar display.
This section explains how to install and setup the GC-8 (mainly consisting of the
GYRO CONVERTER Board) and set it up according to gyrocompass connected.
Installation and connection of the GYRO
CONVERTER Board
Necessary Parts: GC-8-2 (008-446-520)
emaNepyTytQ.oNedoC
draoBretrevnoCoryG6011P461022-214-400
swercSW0072C,8x3M5404-188-000
rekcitS11202-410-461107-231-001
1) Turn off the power.
2) Open the display unit. See Chapter 1 for instructions.
3) Fasten the GYRO CONVERTER Board inside the display unit with four
washerhead screws (supplied).
PTU BOARD
03P9245A F
MB BOARD
03P9251
INT BOARD
03P9252
GYRO CONVERTER
BOARD 64P1106
Figure 4-1 Display unit, inside view