Filter
Top Products
13
ARP-10 INSTALLATION
Necessary Parts
The Auto Plotter ARP-10 is an optional cir-
cuit board which is accommodated in the dis-
play unit of the FR-7062 to provide manual
or automatic acquisition of 10 radar targets.
ARP-10 Installation Kit (000-086-852)
traPepyT.oNedoCytQ
01-PRA
draoB
7009P81039-674-8001
recapS02-QS056-108-0003
gnirpS
rehsaW
3M
W1915C
402-468-0003
daeHnaP
wercS
8X3M
W0072C
404-188-0003
daeHnaP
wercS
rehsaw/w
8X3
01MRWS
477-508-0003
Note: Spacers, spring washers and pan head
screws are not used.
In addition to the ARP-10 Board, a heading
sensor which outputs heading data in AD for-
mat in 25 msec intervals (for example,
FURUNO PG-1000) is required.
Installation
1. Unfasten six screws to remove the display
unit cover.
2. Mate connector J107 on the SPU Board
with connector P107 on the ARP-10
Board.
3. Fix the ARP-10 Board with three pan head
screws (supplied).
Pan Head
Screw
w/washer
3 x 8
3 pcs.
J107
P107
SPU Board
SPU9211B
ARP-10 Board
18P9007
FRONT
REAR
Figure 30 How to install the ARP-10