Filter
Top Products
1-11
12. Pass the cable from the rotation detector through two cable clamps.
Rotation detector
Cable clamps
Cable tie
(Another should
be inside.)
Antenna unit, clamping the rotation detector cable
13. Follow the instructions on the label inside the mounting base to secure the snap assy.
14. Confirm that the rubber gasket is properly positioned and that the triangle mark on the
radome cover is aligned with the triangle mark on the mounting base, then tighten the
fixing screws for the cover. See the sectional view on page 1-9 for how to position the
rubber gasket.
Mounting the optional mounting bracket
A mounting bracket for fastening the antenna unit to a mast on a sailboat is optionally
available.
Contents of mounting bracket 2 kit Type: OP03-93, Code No.: 008-445-080
Part Type Code No. Qty
Hex. bolt M4x12 000-804-725 4
Hex. bolt M8x20 000-805-707 8
Mounting plate 03-018-9001-0 100-206-740 1
Support plate (1) 03-018-9005-0 100-206-780 1
Support plate (2) 03-018-9006-0 100-206-790 1
Bracket (1) 03-028-9101-0 100-206-810 1
Bracket (2) 03-028-9102-0 100-206-820 1
Fixing plate 03-028-9103-0 100-206-830 2
Assemble the mounting bracket and fasten it to a mast. Fasten the antenna unit to the
bracket. For details, see the figure on the next page.