Filter
Top Products
6. NAVIGATION
6-12
6.5 Affecting the Destination Set at Primary Unit to
Secondary
When multiple GP-7000 series plotters are connected, the C-LINK feature may be ac-
tivated to duplicate at the secondary plotter the destination set at the primary plotter.
With C-LINK not turned Off, destination may also only be set at the primary plotter.
As for secondary units, a "mirror chart card" which mirrors the same area data in the
C-MAP MAX chart card in the primary unit, is available. This economical card can be
obtained from your dealer.
1. Press the [MENU] key to show the menu bar.
2. Rotate the [ENTER] knob to choose ADVANCED from the menu bar and then
push the [ENTER] knob.
3. Rotate the [ENTER] knob to choose INPUT/OUTPUT and then push the [ENTER]
knob.
4. Rotate the [ENTER] knob to choose C-LINK and then push the [ENTER] knob.
5. Choose Secondary Station, Primary Station or Off as appropriate and then push
the [ENTER] knob.
Secondary Station: This unit is designated as the secondary plotter. Destination
cannot be set or changed from the secondary plotter.
Primary Station: This unit is designated as the primary plotter.
Off: C-link feature is turned off.
When multiple units are installed, designate only one unit as the primary plotter.
All other units should be designated as secondary stations.
6. Press the [MENU] key to close the menu.
Note: If two or more GP-7000 series plotters are set as primary, the message "Both
chart plotters are set as Primary station." appears with audible alarm.
Secondary Station
Primary Station
Off