Filter
Top Products
2. BASIC OPERATION
2-2
2.2 Turning On/Off
Press the [POWER/BRILL] key to turn the unit on. (For PG-500, see Note 2
shown below.) A beep sounds and the equipment proceeds in the sequence
shown below, showing product information and startup test results. The startup
test checks the ROM, RAM, backed up data and communication between the
control unit and processor unit, and also checks for the presence of heading
from the sensor and rudder angle information from the rudder angle indicator. If
NG appears, an appropriate message will also appear on the screen. If NG is
shown, contact your dealer for advice.
START UP TEST
ROM
PROCESSOR OK 6454002-**.**
CONTROL OK 6454001-**.**
RAM
PROCESSOR UNIT OK
CONTROL UNIT OK
BACK UP DATA
PROCESSOR UNIT OK
CONTROL UNIT OK
HEADING DATA OK 359.9
6454101-**.**
RRU OK P12.3
CONTROLLER ID 1
AUTO PILOT
NAVPILOT-500
FURUNO ELECTRIC CO., LTD
**.** : Program version no.
Startup sequence
After the startup test is completed, “STBY” appears on the screen. This means
that the equipment may now be operated manually by pressing the PORT /
STBD buttons.
Note 1: The first time you turn on the power, you are asked which mode is used
from among Normal, Installation and Simulation. Rotate the course
control knob to select the appropriate mode, and then press the knob.
Note 2: When the Integrated Heading Sensor PG-500 is connected, turn on the
NAVpilot-500 and wait four minutes before leaving port in order to allow
time for the PG-500 heading data to stabilize.
Turning the power off
Press and hold down the [POWER/BRILL] key until the screen goes blank.