Filter
Top Products
4. MENU OPERATION
4-2
4.1.1 Setting parameters
The PARAMETER SETUP menu sets various parameters for the control of the
NAVpilot-500.
1. In the STBY mode, press the [MENU] key to open the STBY mode menu.
2. Rotate the course control knob to select “PARAMETER SETUP”.
3. Press the course control knob to show the PARAMETER SETUP menu.
SEA STATE:
DEVIATION LEVEL: AUTO
MANUAL PARAMETERS
AUTO TRIM: ON 40
ADVANCED AUTO: OFF
AUTO NET TOWING : OFF
NEXT PAGE
PUSH MENU KEY TO RETURN
TO PREVIOUS MENU.
FULL-AUTO
PREVIOUS PAGE
NAV MODE: XTE
NAV MODE DATA SOURCE:
PORT 1
RADIUS OF ORBIT: 0.50 nm
SPIRAL SPEED: 1.0 kt
FISHING MODE: OFF
WAYPOINT SWITCHING: AUTO
SPEED CALICULATION:
SOG
PUSH MENU KEY TO RETURN
TO PREVIOUS MENU.
Page 1
Page 2
Parameter setup menu
4. To close the PARAMETER SETUP menu, press the [MENU] key.
Selecting the method of entering the parameter
The NAVpilot-500 has an automatic adjustment feature which sets up the equipment
according to ship’s characteristics and sea state for optimum performance in the AUTO and
NAV modes. In addition, a self-learning algorithm is incorporated: Parameters for rudder
ratio, counter rudder and auto trim gains are constantly optimized based on the steering
history of your boat, and are stored in memory for future navigation.
You choose how the NAVpilot-500 will steer the vessel, (manual or automatic sea state
parameter adjustment) as follows:
1. Rotate the course control knob to select “SEA STATE” from the PARAMETER SETUP
menu.
2. Press the course control knob to show the sea state options window.
SEMI-AUTO
MANUAL-CALM
MANUAL-MODERATE
MANUAL-ROUGH
FULL-AUTO
Sea state options window