Filter
Top Products
1. INTRODUCTION
1-12
1.4.3 How to select the data to show in the STBY mode
You can select the data to show in the STBY mode as follows:
1. Short press the STBY key to go to the STBY mode.
2. Press the STBY key again to select a display. For example, select the nav data
display.
3. Push the Course control knob. The item selected by the cursor is circumscribed
with a thick rectangle, as in the illustration below.
4. For multi-data display, press W or X to put the cursor on the data to change.
5. Rotate the Course control knob to select the data (or graphic) (Graphic displays:
Depth graph, Temperature graph, Engine speed, Compass rose, Rudder, High-
way, Wind)
6. Push the Course control knob.
MODE
COURSE HEADING
NAV DATA NAV DATA
MODE
COURSE HEADING
NAV DATA NAV DATA
Cursor