Filter
Top Products
2. STEERING MODES
2-11
2.5 TURN Mode
The TURN mode provides three preset turning motions: 180°, 360°, and User. These
turns are available in the AUTO mode and in clockwise and counterclockwise direc-
tions.
For the User turn, you can confirm and change the parameters of the turn before you
do the turn. If confirmation or change is not necessary in these turns, simply push the
Course control knob after selecting the turn with the TURN key.
This function is not available when [SHIP’S CHARACTERISTICS] (on the Installation
menu) is set for [SAILBOAT].
2.5.1 How to select a turn and start the turn
Select the 180°, 360°, or User turn as follows:
1. Press the TURN key to show the Turn menu.
2. Rotate the Course control knob to select a turn. The cursor highlights current se-
lection. See the next section for description of turns.
Note 1: You can set the parameters for the User turn (before starting the turn) by
pressing the X key. For details, see section 2.5.4.
Note 2: Only [180° TURN], [360° TURN], and [USER TURN] are available with
Fantum Feedback
TM
.
3. Push the Course control knob to start the turn.
After you start the turn, the steering mode indications shows "XXXT" (XXX=turn an-
gle), the message "BEGINNING TURN" appears, and the buzzer sounds. After the
turn is completed, the message "THE TURN ENDED" appears.
To escape from a turn, press the STBY key.
NAVpilot-700 NAVpilot-711/NAVpilot-720
S
P
S
P
S
P
S
P
S
P
S
P
S
P
S
180° TURN 360° TURN USER TURN CIRCLE TURN
ORBIT TURN SPIRAL TURN FIGURE 8
TURN
SQUARE
TURN
ZIGZAG
TURN
P