Filter
Top Products
2 GPSMAP 76Cx Owner’s Manual
GettInG Started
Batteries, microSD Card, and Lanyard
The GPSMAP 76Cx operates on two AA batteries
(not included), which are located in the back of
the unit. You can use Alkaline, NiMH, or Lithium
batteries. See page 34 for information on setting the
battery type.
To install the batteries:
1. Remove the battery cover
by turning the D-ring 1/4
turn counter-clockwise and
pulling the cover loose.
2. Insert the batteries,
observing the proper
polarity.
3. Reinstall the battery cover.
Remove the batteries from your
unit when you do not expect to
use the unit for several months.
Stored data is not lost when
batteries are removed.
To install the microSD card:
1. Remove the battery cover by turning the D-ring
1/4 turn counter-clockwise and pulling the cover
loose.
2. Locate the microSD card in the slot below the
batteries and press down on the top edge of the
card until you feel it click. Then gently allow the
card to release.
3. Press down again to install
the card, making certain
the card is fully in place
to prevent damage when
reinstalling the battery
cover.
To install the lanyard:
1. Place the loop of the
lanyard throught the slot at
the base of the unit.
2. Route the strap through
the loop, and pull tight.
MICRO
SD
CARD
microSD card slot
(with microSD card in
position for insertion)
Install the carry lanyard
in the slot at the bottom
of the unit