60 GPSMAP 700 Series Owner’s Manual
Radar
Hiding the VRM and the EBL
1. From the Home screen, select .
2. Select , , or .
3. Select > > .
Measuring the Range and Bearing to a Target Object while VRM and EBL are Hidden
If you have hidden VRM and EBL (page 60), you can quickly display the range and bearing to a location by
touching the screen.
1. From the Home screen, select .
2. Select , , or .
3. Touch a location.
4. Select .
Measuring the Distance to a Point on the Radar Screen
You can touch a point on the radar screen to display the distance and bearing of that location from your present
location in the upper-left corner of the screen.
1. From the Home screen, select .
2. Select , , or .
3. Touch a location on the screen.
4. Select .
5. If necessary, select to measure from the selected location rather than your present location.
Waypoints and Routes on the Radar Screen
Marking a Waypoint on the Radar Screen
1. From the Home screen, select .
2. Select a radar mode.
3. Touch a location.
4. Select .
Showing Waypoints on the Radar Screen
You can show waypoints that are within the range shown on the Radar screen. This setting does not apply to
the Radar Overlay.
1. From the Home screen, select > > > .
2. Complete an action:
• Select to show all waypoints.
• Select to show only waypoints associated with the currently active route.
Hiding Waypoints on the Radar Screen
You can hide waypoints that are within the range shown on the Radar screen.
From the Home screen, select > > > > Select .
Navigating a Saved Route on the Radar Screen
Before you can browse a list of routes and navigate to one of them, you must record and save at least one route
(page 28). Navigation lines must be showing in order to view a route on the Radar screen (page 68).
1. From the Home screen, select > .
2. Select a route.
3. Select .
4. Complete an action:
• Select to navigate the route from the starting point used when the route was created.
• Select to navigate the route from the destination point used when the route was created.
5. From the Home screen, select .