Filter
Top Products
Setup
3A1569B 17
Step Two - Install Power Jumpers
Find location for power jumpers which are in a plastic
bag tie wrapped to the ground lug.
1. Turn screws counter-clockwise on the upper part of
the shroud until they stop. Pull door up and out.
2. Install red jumpers from the storage bag to the
positions shown for your power.
• Push the jumper firmly into the new position.
• If necessary, a flat-blade screwdriver can be
used under the ridge on the side of the jumper
to remove them.
3. Replace front shroud.
Step Three - Reposition Heater Jumpers
(if necessary)
Find location of Heater Jumpers.
Machines are shipped with heaters wired for 6000 watts.
To reposition heater jumpers for 3000 watts, change
jumper positions as shown below.
1. Turn screws counter-clockwise on the upper part of
the shroud and remove by pulling them out.
2. Move red jumpers from the storage positions to the
positions shown for your power.
• A flat-blade screwdriver can be used under the
ridge on the side of the jumper to remove them.
• Push the jumper firmly into the new position.
3. Replace lower front shroud.
Power Jumper Location
Heater Jumper Location
NEW
ti17569a
Heater Jumpers
Install Power Jumpers
230V 1ø 230V 3ø Delta 380V 3ø WYE
Step Two
TB2
Terminal Blocks
Install red jumpers
Step Three
TB2
Terminal Blocks
Position red jumpers
3000 WATTS6000 WATTS