Filter
Top Products
Initial Startup
3A1569B 21
Initial Startup
Load Fluid with Feed Pumps
NOTE: The Reactor is tested with oil at the factory.
Flush out the oil with a compatible solvent before spray-
ing; see page 27.
1. Check that Setup process is complete; see page 15.
2. Turn on component B agitator, if used.
3. Turn both PRESSURE RELIEF/SPRAY valves (SA,
SB) to SPRAY.
4. Open both fluid valves (FV).
5. Start feed pumps. Do not start proportioner air
motor or pumps.
6. Purge air from hoses.
a. For Probler P2 guns: Loosen hose fittings and
bleed out air until air-free fluid comes from
hoses.
b. For Fusion guns: Hold gun fluid manifold over
two grounded waste containers. Open fluid
valves A and B until clean, air-free fluid comes
from valves. Close valves.
Pressure Check Hose
See hose manual. Pressure check for leaks. If no leaks,
wrap hose and electrical connections to protect from
damage.
Do not operate Reactor without all covers and
shrouds in place.
Always provide two grounded waste containers to
keep component A and component B fluids separate.
SB
SA
ti8442a
FV
ti17571a
TI2484a
The Fusion AP Gun is shown.