Filter
Top Products
Fluid Circulation
3A1569B 31
Circulation Through Gun
Manifold
Circulating fluid through the gun manifold allows rapid
preheating of hose.
1. Install gun fluid manifold (P) on accessory circula-
tion kit (CK). Connect high pressure circulation lines
(R) to circulation manifold.
2. Route circulation lines back to respective compo-
nent A or B supply drum. Use hoses rated at the
maximum working pressure of this equipment. See
manual for installation instructions.
3. Follow Initial Startup, page 21.
4. Turn main power ON .
5. Set temperature targets, see page 22. Turn on
, , and heat zones by pressing
.
6. Press to display actual temperatures.
7. Turn the air regulator to a low pressure until
and temperatures reach targets. Increase
the pressure once the temperatures are on target.
Do not circulate fluid containing a blowing agent
without consulting with your material supplier
regarding fluid temperature limits.
Table 1: Circulation Kit (CK)
Part Gun Manual
246362 Fusion AP 309818
256566 Fusion CS 313058
GC1703 Probler P2 313213
R
CK
P
ti2767a
The Fusion AP gun manifold is shown.
A
B
A
B