Filter
Top Products
Installing Components
4-4 HP 10000 Series Rack Reference Guide
HP CONFIDENTIAL
Writer: Amy L. Laffitte File Name: e-ch.4-Components
Codename: Mastiff Part Number: 258200-002 Last Saved On: 10/15/02 3:50 PM
Installation Overview
NOTE: The stabilizer feet should be installed prior to any component installation.
IMPORTANT: The installation instructions below are for standard installations. For specific
installation instructions, refer to the documentation included with your component.
The following steps outline the sequence for installing rack-mountable components
in a rack. You should install zero U devices first, such as PDUs, switch boxes, and
so on.
1. Use the template to measure and mark the rack for correct placement of the
installation hardware.
2. Install the cage nuts into the rack.
3. Prepare and install the adjustable fixed and/or sliding rails.
4. Prepare the component for mounting in the rack.
5. Install the component into the rack and secure it.
6. Attach the cable management arm to the rack and then to the component.
7. Attach any cables and power cords, being sure that you adhere to all cautions and
warnings contained in the individual component installation instructions.
8. Remove the cable access panel and route the cables.