Filter
Top Products
Installing Components
4-18 HP 10000 Series Rack Reference Guide
HP CONFIDENTIAL
Writer: Amy L. Laffitte File Name: e-ch.4-Components
Codename: Mastiff Part Number: 258200-002 Last Saved On: 10/15/02 3:50 PM
Installing the Component
After all rack-mounting hardware has been installed on the component you can insert
it into the rack.
WARNING: Components can be very heavy. To reduce the risk of personal
injury or damage to the equipment:
• Remove all pluggable power supplies and modules to reduce the weight of
the product before lifting it.
• Observe local occupational health and safety requirements and guidelines
for manual material handling.
• Get help to lift and stabilize the product during installation or removal,
especially when the product is not fastened to the rails.
• When installing the product into or removing the product from the rack,
the product is unstable when not fastened to the rails.
Inserting the Component into the Rack
IMPORTANT: Read and adhere to the cautions and warnings in this section.
To install a component into the rack:
1. Be sure that you have an adequate number of individuals or a mechanical lifting
device to help you install the component into the rack.
2. Fully extend the sliding rails.
3. With the unit well supported, lift it up and align the component rails on the
component with the sliding rails secured to the rack.