Filter
Top Products
Installing Components
HP 10000 Series Rack Reference Guide 4-5
HP CONFIDENTIAL
Writer: Amy L. Laffitte File Name: e-ch.4-Components
Codename: Mastiff Part Number: 258200-002 Last Saved On: 10/15/02 3:50 PM
Using the Template
Use the template that was shipped with your rack-mountable component to mark the
location of the mounting hardware on the mounting rails of the rack.
1. Push back the tabs (marked ★) in the top of the template and place them in the
correct holes in the mounting rails.
2. Match up the hole pattern indicated on the sides of the template with the hole
pattern in the mounting rails.
Make sure you begin measuring in the correct place. If a rack component is already
installed immediately below the planned position of the new component, place the
template on top of the previously installed component and against the front
mounting rails.
Figure 4-1: Measuring with the template
3. Use the front of the template to mark the attachment points for rack-mounting
brackets, rails, components, or cage nuts on the front of the rack.
4. Use the back of the template to mark the attachment points for rack-mounting
brackets, rails, components, or cage nuts on the back of the rack.