Filter
Top Products
11
TRANSOM TRANSDUCER INSTALLATION
If you will be installing a transom mounted transducer, use the procedures in this
section. There are several procedures you will have to perform in order to install a
transom-mounted transducer. They are:
• Determine transducer mounting location
• Mount the bracket to the boat
• Attach the pivot to the transducer
• Mount the transducer pivot assembly to the bracket
• Adjust the running position of the transducer
• Route the transducer cable
• Perform a final test of the transom transducer installation.
To determine transducer mounting location:
NOTE: If transom mounting is not possible because of a stepped hull or cavitation noise, and
you have a single layer fiberglass hull, In-hull installation is an option. See Inside the Hull
Transducer Installation for more information.
1. First, determine the best location on the transom to install the transducer.
Consider the following to find the best location:
• It is very important to locate the transducer in an area which is relatively free of
turbulent water. As a boat moves through the water, turbulence is generated by
the weight of the boat, and the thrust of the propeller(s) - either clockwise or
counter-clockwise. This turbulent water is normally confined to areas immediately
aft of ribs, strakes or rows of rivets on the bottom of the boat, and in the immed-
iate area of the propeller(s). Clockwise propellers create more turbulence on the
port side. On outboard or inboard/outboard boats, it is best to locate the
transducer at least 15" (380 mm) to the side of the propeller(s).
• The best way to locate turbulence-free water is to view the transom while the boat
is moving. This method is recommended if maximum high-speed operation is a
high priority. If this is not possible, select a location on the transom where the hull
forward of this location is smooth, flat and free of protrusions or ribs.
• The hydrodynamic shape of your transducer allows it to point straight down
without deadrise adjustment.
• On boats with stepped hulls, it may be possible to mount the transducer on the
step. Do not mount the transducer on the transom behind a step to avoid popping
the transducer out of the water at higher speeds; the transducer must remain in
the water for the control head to maintain the sonar signal.
• If the transom is behind the propeller(s), it may be impossible to find an area clear
from turbulence, and a different mounting technique or transducer type should
be considered (see Inside the Hull Transducer Installation).
Stepped Hull
Rivets/Strakes
1
Deadrise Angle
2
Step
3
1
2
3
531374-1_A - 947 Man.qxd 2/15/2005 7:53 PM Page 16