Filter
Top Products
60
SURFACE CLUTTER
(Advanced)
Surface Clutter adjusts the filter that removes surface clutter noise caused by algae
and aeration. The lower the setting, the less surface clutter will be displayed. The
Surface Clutter menu choice is available when User Mode is set to Advanced (see Setup
Menu Tab: User Mode).
T
o change the Surface Clutter setting:
1. Make sure you are in Advanced User Mode, then
highlight Surface Clutter on the Sonar main menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control
keys to change the Surface Clutter setting.
(Low = 1 to High = 10, Default = 5)
NOISE FILTER
(Advanced)
Noise Filter adjusts the sonar Noise Filter to limit interference on the display from sources
such as your boat engine, turbulence, or other sonar devices. The Noise Filter menu choice
is available when User Mode is set to Advanced (see Setup Menu Tab: User Mode).
NOTE: The Off setting removes all filtering; Low, Medium and High settings add progressive
filtering of the sonar returns. In some deep water situations, the High setting may actually
make it harder for the control head to find the bottom.
To change the Noise Filter setting:
1. Make sure you are in Advanced User Mode, then highlight Noise Filter on the
Sonar main menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Noise Filter
setting. (Off, Low, Medium, High, Default = Off)
MAX DEPTH
(Advanced)
Max Depth adjusts the maximum depth of 2D operation. The performance of your
900 series™ can be tuned to the maximum depth you will be fishing in by setting the
Max Depth. When a maximum depth is set, your 900 series™ will not attempt to
acquire sonar data below that depth, thus increasing overall performance. When Max
Depth is set to Auto, the 900 series™ will acquire bottom readings as needed (within
the capacity of the unit). If the bottom is deeper than the Max Depth setting, the
digital depth readout will flash, indicating that the 900 series™ cannot locate the
bottom. The Max Depth menu choice is available when User Mode is set to Advanced
(see Setup Menu Tab: User Mode).
T
o change the Max Depth setting:
1. Make sure you are in Advanced User Mode and in a 2D Sonar View, then
highlight Max Depth on the Sonar main menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Max Depth
setting. (AUTO, 10 to 1000 feet, 3 to 330 meters [International Models Only],
Default = AUTO)
Surface Clutter
531374-1_A - 947 Man.qxd 2/15/2005 7:54 PM Page 65