Filter
Top Products
4
Menu - Press the MENU key once for the X-Press
TM
Menu. The X-Press
TM
menu allows you to access the settings that you change frequently
without having to navigate through a menu system. Only the
X-Press
TM
menu items associated with the current view are
displayed. Either the Sonar or Navigation X-Press
TM
Menu will
appear, depending on the view you are in.
Press the MENU key twice for the Main Menu System. The menu system is organized
under tab headings to help you find a specific menu item quickly. In the main Menu,
first use the 4-Way Cursor Control LEFT or RIGHT key to select a tab; then use the
DOWN or UP key to select the menu item. The menu system is expandable; when
you attach a supported accessory to the Matrix system, the Matrix menus may
change to display new choices for those accessories that require menu access.
NOTE: Instruction guides included with the accessory will detail accessory-specific
features and functions.
4-Way Cursor Control - Use the DOWN or UP arrow keys to
select a menu item. Use the LEFT or RIGHT arrow keys to make
a menu choice.
NOTE: Menu choices are implemented and saved immediately - no
further action is required.
Zoom (+/-) - Press the - or + ZOOM keys while in any of the Chart Views or the
Sonar Zoom View to change the scale of the view to appear closer or farther away.
Mark - Press the MARK key while in any view to mark the position
of a waypoint, either at the current boat location, or, if the Cursor
is active, at the current Cursor location.
GOTO - If the Cursor is active, pressing the GOTO key while in any
view creates a waypoint and starts navigation towards that
waypoint. If the Cursor is not active, pressing the GOTO key
displays the list of waypoints, so that you can select the
waypoint towards which you want to navigate.
5
Exit - The EXIT key has multiple functions, depending on the situation:
• If an alarm is sounding, pressing EXIT will cancel the alarm.
• If a menu tab is selected, pressing EXIT will exit the menu
mode and return to the view.
• If a menu is active, pressing EXIT will return to the previous
level in the menu system.
• If a cursor is active on the display, pressing EXIT will clear
the cursor from the display.
P
P
ow
ow
ering Up the Unit - S
ering Up the Unit - S
tar
tar
t
t
-Up Scr
-Up Scr
een
een
Turn on the Matrix unit by momentarily pressing the POWER key. The Start-Up
screen is then displayed until the Matrix unit begins sonar operation. While the
Start-Up screen is displayed, you may press the MENU key for the other options
listed below. If no key is pressed, the Matrix will begin Normal or Simulator
operation, depending on the presence or absence of a transducer. The following
operating states are available:
• Normal – Use for on the water operation with transducer connected. The
Matrix unit uses advanced transducer detection methods to determine if a
transducer is connected. If a functioning transducer is connected, the unit
will select the Normal operating state automatically and the unit can be
used on the water.
• Simulator – Use to learn the features and functions of the Matrix unit.
Simulates on the water operation. If a transducer is not connected or is
damaged, the unit will select the Simulator state automatically at startup.
NOTE: When operating in Simulator state with a transducer connected, Menu setting
changes are saved to memory. If a transducer is not connected, changes will not be saved
and Menu settings will revert to factory defaults every few minutes.
• System Status – Use to view system connections and conduct a unit self-test.
(See Installation Confirmation and System Status - Start-Up Menu for more
information about using System Status)
• PC Connect – Use when upgrading Matrix internal software with a PC and
PC Connect cable. (See PC Connect - Start-Up Menu for more information
about using PC Connect)
M5565_ManE_531192-1_A.qxd 5/4/2003 9:38 PM Page 8