Filter
Top Products
46
FIGURE 2
2A. BLADE SHAFT BOLT: Use to clamp the diamond
blade between the inner and outer ange. Right
side of saw has left hand threads. Left side of saw
has right hand threads.
2B. OUTER FLANGE: Use to hold the diamond blade
in position.
2C. OUTER FLANGE ARBOR: Use to support the
diamond blade.
2D. LOCKING PIN: Use to prevent the diamond blade
from rotating on the shaft during operation.
2E. DIAMOND BLADE: Use as the cutting tool for
concrete and asphalt surfaces.
2F. INNER FLANGE: Inside support used to hold the
diamond blade in position.
2G. BLADE GUARD NOSE LATCH: Use to latch the
front part of blade guard down.
2H. BLADE GUARD FRONT: The front part of the blade
guard.
2I. BLADESHAFT: Supports Blade Flanges and
FIGURE 3
3A. ENGINE GEARBOX:
3B. WATER CONNECTION: Circulates freshwater
through gearbox to cool it. Water then ows to the
bladeguard.
3C. WATER DRAIN VALVE: Twist and push up to drain
water from gearbox. Drain daily to prevent corro-
sion or damage due to freezing temperatures.
3D. BELT GUARDS: Remove to install new v-belts
and check v-belt tension. (2) per, Keep in place.
3E. FLANGE COVER:
3F. BELT PROTECTOR SHIELD: Keep in place.
3G. BLADESHAFT TUBE ASSY: Sealed unit contains
bladeshaft, bearings and shaft seals.
3H. TIEDOWN LUGS: Used to tie the saw down while
transporting by vehicle. Not to be used to lift the
saw.
3I. ENGINE OIL DRAIN VALVE: Drains engine oil
without use of tools.
3J. BELT TENSIONING BOLTS:
3K. HORIZONTAL CLAMPING BOLTS:
3L. BLADE SHAFT PULLEY:
3M. V-BELTS: Set of 4, 4 Groove
3N. GEARBOX PULLEY: