Filter
Top Products
47
FIGURE 5
FIGURE 4
4A. BLADESHAFT BEARING SEALS
4B. FRONT WHEEL BEARINGS
4C. FRONT AXLE PIVOT BEARINGS
4D. HYDRAULIC CYLINDER PIVOT PIN
4E. REAR AXLE
4F. HYDRAULIC WHEEL MOTOR
4G. RAISE LOWER CYLINDER
4H. LINEAR ACTUATOR
5E. FUEL BLEED VALVE: Open to bleed air from fuel
lines.
5F. FUEL FILTER WATER SEPARATOR: See John
Deere engine manual.
5G. GEARBOX FILL/VENT PLUG: Change every 500
hours. 32OZ. Capacity 75W90 Gearlube.
5H. D.C. (direct current) LIFT PUMP: Raises and
lowers the saw.
5I. HYDRAULIC RESERVOIR FILL: Fill and check
hydraulic system uid here.
5J. HYDRAULIC RESERVOIR: 1.5 Quarts
5K. HYDRAULIC FILTER: Filters hydraulic system
uid.
5L. ENGINE OIL DRAIN HOSE: Connects to oil drain
valve 3I. Use to drain engine oil.
5M. TRANSMISSION BYPASS VALVE: Turn counter
clockwise to open. Turn clockwise to close. Open
to push concrete saw.
5N. HYDROSTATIC TRANSMISSION PUMP.
5O. ALTERNATOR/WATERPUMP BELT: Self
Tensioning. See JohnDeere for replacements.
5P. ALTERNATOR: See Joh n D eere for
replacements.
FIGURE 5
5A. AIR FILTER ASSEMBLY: Includes
a) Housing
b) Cover
c) Primary Outer Element: Clean or replace when
restriction indicator shows the RED warning.
d) Inner Safety Element: DO NOT CLEAN this lter
element. Replace 1 time per year or if it becomes
damaged.
5B. RADIATOR COOLANT FILL: Fill radiator from
this point. Replace cap if damaged.
5C. ENGINE OIL FILL: One of two ll points.
5D. FUEL HAND PRIMER PUMP: Push to prime fuel
lines to help intial startup or as needed.