Filter
Top Products
55
17 Repairs
We carry out all repairs in the shortest possible time and
at the most economical prices. (See back page for our
address and phone numbers.) Contact you authorized
Dealer concerning maintenance and repairs.
18 Spare Parts
For quick supply of spare parts and to avoid any lost time,
it is essential to quote the data on the manufacturers
plate xed to the machine and the part number(s) and
description to be replaced with every order.
Please reference Parts Lists manual (542 20 10-32):
(If you do not have a Parts List Manual, please call TOLL
FREE 1-800-288-5040 in USA, or for International, call
+1-913-928-1300.)
The instructions for use and spare parts found in this
document are for information only and are not binding. As
part of our product quality improvement policy, we reserve
the right to make any and all technical modications
without prior notice.
The manufacturer accepts no responsibility
caused by unsuitable use or modications.
16 Large Diameter Models
The FS8400 can be configured with a 60” (1500mm)
diameter blade capacity. The 60” drive can be ordered
from the factory or can be recongured by ordering the
conversion kit 542 19 96-25. See the Blade Size Conversion
Chart for specics. Depth of cut of 25” can be achieved.
The large diameter model includes a frame extension,
60” blade guard and a blade shaft assembly with 10”
diameter flanges. The Flanges have the following
pattern.
The Blade Hole pattern must match. Six (6), ½-13 x
2.5” long Hex Head Cap Screws pass through the outer
ange through the blade core and thread into the inner
ange supplying the clamping force to hold the blade.
Use ½” lock washers with the clamping bolts. Also use
the 5/8-11 x 4.0” Cap Screw, LH or RH thread through the
center of the ange. Husqvarna will supply blades with
this hole pattern.
The FS8400, when equipped with a 60” drive system is
very heavy and the machine balance is greatly affected
by installing or removing a blade. To counter the large
balance changes, a weight box is mounted on the left or
right rear of the saws. Weights can be easily removed
and added to quickly adjust the machine balance to meet
the operator’s needs.
OPTIONAL KITS:
542 18 11-17* Dual Light Kit
542 19 96-26 Water Pump Kit