Filter
Top Products
TH-K2AT/K2E/K2ET
29
D. S-meter (Two segments in S-meter light, all segments
in S-meter light)
1S-meter (Two segments in S-meter light)
(1)Press the [LAMP] or [MONI] key on the transceiver to display
“S1” on the LCD.
The current RSSI level value is displayed at the lower digits
of the frequency display, and the value stored in the
EEPROM is displayed on the memory channel number
display.
(2)Press the [MENU] key to write the current RSSI level value
into the EEPROM.
2S-meter (All segments in S-meter light)
(1)Press the [LAMP] or [MONI] key on the transceiver to display
“S9” on the LCD.
(2)Press the [MENU] key to write the current RSSI level value
into the EEPROM.
E. RX BPF (Lower limit frequency, center frequency, upper
limit frequency)
1RX BPF (Lower limit frequency)
(1)Press the [LAMP] or [MONI] key on the transceiver to display
“BPL” on the LCD.
The current BPF tuning value is displayed at the lower digits
of the frequency display, and the value stored in the
EEPROM is displayed on the memory channel number
display.
(2)Press the [VFO], [MR] or [CALL] key to switch to the
frequency display.
(3)Turn the encoder to display the lower limit frequency on
the LCD.
(4)Press the [CALL] key to switch to the adjustment display.
(5)Turn the encoder to change the current BPF tuning value
and adjust RX BPF.
(6)Press the [MENU] key to write the current BPF tuning value
into the EEPROM.
2RX BPF (Center frequency)
(1)Press the [LAMP] or [MONI] key on the transceiver to display
“BPC” on the LCD.
(2)Press the [VFO], [MR] or [CALL] key to switch to the
frequency display.
(3)Turn the encoder to display the center frequency on the
LCD.
(4)Repeat steps (4) to (6) of “1RX BPF (Lower limit
frequency)” described on page 29.
3RX BPF (Upper limit frequency)
(1)Press the [LAMP] or [MONI] key on the transceiver to display
“BPH” on the LCD.
(2)Press the [VFO], [MR] or [CALL] key to switch to the
frequency display.
(3)Turn the encoder to display the upper frequency on the
LCD.
(4)Repeat steps (4) to (6) of “1RX BPF (Lower limit
frequency)” described on page 29.
F. 7.5V TX H power (Lower limit frequency, center
frequency, upper limit frequency)
17.5V TX H power (Lower limit frequency)
(1)Press the [LAMP] or [MONI] key on the transceiver to display
“P7L” on the LCD.
In this case, the “
” icon appears.
The current APC value is displayed at the lower digits of
the frequency display, and the value stored in the EEPROM
is displayed on the memory channel number display.
(2)Press the [VFO], [MR] or [CALL] key to switch to the
frequency display.
(3)Turn the encoder to display the lower limit frequency on
the LCD.
(4)Press the [CALL] key to switch to the adjustment display.
(5)Press the [PTT] key to enable the transmit mode.
(6)Adjust the output voltage from DC power supply until the
voltage at the battery terminal becomes 7.5V while the
transceiver is transmitting.
(7)Turn the encoder to change the current APC value and adjust
the transmission power.
ADJUSTMENT