Filter
Top Products
TH-K2AT/K2E/K2ET
34
ADJUSTMENT
(4)Press the [CALL] key to switch to the adjustment display.
(5)When the [PTT] key is pressed to enable transmit mode, a
preset DCS code (023) is internally generated and
modulated.
(6)Turn the encoder to change the current adjustment value
and adjust DCS deviation.
(7)Press the [MENU] key to write the current adjustment value
into the EEPROM.
2DCS deviation (Center frequency)
(1)Press the [LAMP] or [MONI] key on the transceiver to display
“DVC” on the LCD.
In this case, the “
” icon appears.
(2)Press the [VFO], [MR] or [CALL] key to switch to the
frequency display.
(3)Turn the encoder to display the center frequency on the
LCD.
(4)Repeat steps (4) to (7) of ”1DCS deviation (Lower limit
frequency)” described on page 33.
3DCS deviation (Upper limit frequency)
(1)Press the [LAMP] or [MONI] key on the transceiver to display
“DVH” on the LCD.
In this case, the “
” icon appears.
(2)Press the [VFO], [MR] or [CALL] key to switch to the
frequency display.
(3)Turn the encoder to display the upper limit frequency on
the LCD.
(4)Repeat steps (4) to (7) of ”1DCS deviation (Lower limit
frequency)” described on page 33.
O. VOX sensitivity (Level 1, level 9)
1VOX sensitivity (Level 1)
(1)Press the [LAMP] or [MONI] key on the transceiver to display
“VOX1” on the LCD.
Press the [F] key and then the [PTT] key repeatedly to turn
the “
” icon ON.
The current microphone input level value is displayed at
the lower digits of the frequency display, and the value
stored in the EEPROM is displayed on the memory channel
number display.
(2)Input a specified AG signal to microphone input.
(3)Press the [MENU] key to write the current microphone input
level value into the EEPROM.
2VOX sensitivity (Level 9)
(1)Press the [LAMP] or [MONI] key on the transceiver to display
“VOX9” on the LCD.
(2)Input a specified AG signal to microphone input.
(3)Press the [MENU] key to write the current microphone input
level value into the EEPROM.