Filter
Top Products
H2iSD-26
2010 Hyper-heating Y-SERIES SYSTEM DESIGN (Sept. 2010)
2010 H2i
®
Y-SERIES
SYSTEM DESIGN
4. OUTDOOR INSTALLATION
1.
Do not install in an area where the unit could be subjected to direct heat.
2.
Avoid installing the unit in a location where the operating sound could be an annoyance.
3. Avoid the sites where strong winds blow.
4.
Install on a stable, load-bearing surface.
5.
Ensure there is adequate drain flow from the unit when in heating mode
6.
See space requirements for installation and maintenance.
7. Do not install the unit in an environment that may have combustible gas, oil, steam, chemical gas like acidic solutions,
sulfur gas, etc.
8. To ensure an adequate flow velocity for the exhaust pipe, make sure its horizontal gradient is higher than 1/100.
4-1. Installation Site Requirements