Filter
Top Products
5. WIRING OPTION
5 - 8
(2) MR-EKCBL_M-_
POINT
The following encoder cables are of four-wire type.
MR-EKCBL30M-L
MR-EKCBL30M-H
MR-EKCBL40M-H
MR-EKCBL50M-H
When using these encoder cables, refer to each servo amplifier instruction
manual.
The servo amplifier and the servo motor cannot be connected by these cables alone. The servo motor-
side encoder cable (MR-J3JCBL03M-_-L) is required.
The numbers in the cable length field of the table indicate the symbol filling the underline "_" in the cable
model. The cables of the lengths with the symbols are available.
Cable length
Cable model
20 m 30 m 40 m 50 m
IP rating Bending life Application
MR-EKCBL_M-L 20
(Note)
30
IP20 Standard
MR-EKCBL_M-H 20
(Note)
30
(Note)
40
(Note)
50
IP20
Long
bending life
For HF-KN servo motor
Use in combination with MR-
J3JCBL03M-_-L.
Note. Four-wire type cable
(a) Connection of servo amplifier and servo motor
1)
MR-EKCBL_M-L
MR-EKCBL_M-H
2)
CN2
Servo motor
HF-KN
MR-J3JCBL03M-A2-L
Cable length: 0.3m
Servo amplifier
Cable model 1) CN2-side connector 2) Junction connector
Receptacle: 36210-0100PL
Shell kit: 36310-3200-008
(3M)
Connector set: 54599-1019
(Molex)
MR-EKCBL_M-L
MRR
LG
P5
MR
MDR
MD
P5 MR
MRR
LG
MDR
MD
13 79
428610
5
View seen from wiring side. (Note)
or
4
2
8
6
15
10
37
9
View seen from wiring side. (Note)
MR-EKCBL_M-H
Note. Do not connect anything to the pins shown as
. Especially, pin
10 is provided for manufacturer adjustment. If it is connected with any
other pin, the servo amplifier cannot operate normally.
Housing: 1-172161-9
Connector pin: 170359-1
Crimping tool: 91529-1
(TE Connectivity or equivalent)
Cable clamp: MTI-0002
(Toa Electric Industrial)
MR
123
MRR
MD
456
MDR
P5
789
LG SHD
View seen from wiring side.
CONT