Filter
Top Products
PAGE 18 — GB114BS/BP GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #3 (01/06/09)
OPERATION
RAISING THE EXTENSION POLE
Before raising the extension pole, make sure the 1.
T-handle bolt lock (Figure 6-O) is securely tightened.
This will prevent the balloon/lamp assembly from falling
off. In addition make sure that the lamp power cable
is connected to the mating end of the power source
cable.
Raise extension pole (Figure 6-L) to desired height. 2.
Watch out for any overhead obstructions.
Using 19 mm wrench, tighten extension clamp bolt 3.
(Figure 6-Q) securely. Keep wrench in a safe place
where it will not get lost.
DANGER
ALWAYS make sure the area
above the lighting system is
open and clear of overhead
power lines and other
obstructions. Contact with
overhead power lines or other
obstructions could result in
equipment damage, Serious
Injury or Death!
DANGER
When raising the extension pole, ALWAYS
be on the lookout for overhead obstructions
such as high voltage power lines. The
possibility exists of electrocution, even
death! if the lighting system comes in
contact with high voltage power lines.
APPLYING POWER
Make sure the power ON/OFF switch (Figure 10) 1.
located near the bottom of the ballast is in the OFF
position.
Power OFF/ON Switch (Off Positon)Figure 10.
If using a power source (Figure 11) other than a 2.
portable generator, plug the AC power cord from the
ballast into a 120 VAC, 60 Hz receptacle that is
protected by a at least a 15 amp circuit breaker.
Applying 120 VAC PowerFigure 11.
BALLAST
OFF
ON/OFF
SWITCH
EXTERNAL
SINGLE-PHASE
(120 VAC)
POWER SOURCE
RECEPTACLE
BALLAST
CONNECT
TO BALLOON
POWER
CABLE
AC POWER
CORD
NOTICE
If using a portable generator, start the generator as
referenced in the "Start-up Section" of the supplied
generator manual.
Once the generator has started, plug the AC power cord
from the ballast (Figure 11) into a GFCI receptacle on
the generator.