PAGE 32 — GB114BS/BP GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #3 (01/06/09)
NAMEPLATE AND DECALS
DANGER
To avoid accident or injury
NEVER exceed a travel
speed of 5 MPH when using
lighting system on a mobile
equipment.
DCL 1001
To avoid accident or
injury ALWAYS make
certain hardware is
securely fastened on
pipe clamps.
DCL1002
DANGER
To avoid accident or
injury ALWAYS make
certain hardware is
securely fastened on
pipe clamps.
DCL1002
DANGER
2
2
1
ALWAYS OFFturn lamp
first, before shutting down
generator.
CAUTION
DCL409
LAMP INFORMATION
Once lampis turned
t will take about 20 minutes
beforelampcan beturned
back on.
OFF,
Allow lamp to cool down
before turning back on.
I
DCL404
CAUTION
LAMP COVER BUZZER
Before operating GlowBug
unzip cover, fold into
bag on top of balloon and zip.
ALWAYS
I
naudiblealarmwillsound when
power is applied to the GlowBug.
f the cover has not been removed
a
CAUTION
DCL413
COVER
INFORMATION
NEVER apply power to the
GlowBug until the cover has
been inserted inside the bag
and the balloon is fully exposed.
Before operating GlowBug
unzip cover, fold into
bag on top of balloon and zip.
ALWAYS
Cover
Bag
Zipper
Before storing GlowBug,
fullycoverballoonto
preventdamagefromdust,dirt
and adverse weather conditions.
ALWAYS
DANGER
DCL427
ELECTRICAL
SHOCK HAZARD
To prevent electrical shock or
electrocution, the GlowBug
be connected to an
earth ground.
MUST
(See NEC Article 250)
GROUND
To prevent burns,
ballast or cover while
lamp is on.These surfacesare
extremely hot! allow
sufficient time for both surfaces
to before touching.
NEVER
touch
ALWAYS
cool down
BURN HAZARD
WARNING
DCL415
MODEL
SERIALNO.
LAMP
SWITCH
ON
OFF
DCL424
NEVERtouchalivepowercord
or active electrical components
withwethandsorwhilestanding
in water. The possibility of electrical
shock or even death! exists.
DANGER
DCL410
ELECTRICAL
SHOCK HAZARD
DANGER
D
C
L
41
8
HIGH VOLTAGE
To avoid injury,
you MUST read
and understand
operator’s manual
before using this
machine.
Ask for training
as needed.
This machine to
be operated by
qualified
personnel only.
P/N35137
WARNING
GROUND
S1123
DCL416
DANGER
When replacing lamp and to prevent electrical
shock, shutdown the generator before
replacing lamp. Remember to let lamp cool before
removing. Use only recommended type lamp as
listed in parts manual.
ALWAYS
ELECTRICAL
SHOCK HAZARD
To prevent burns,
touch lamp while lamp is on.
Lamp surface gets extremely
hot! allowsufficient
time for lamp to
before touching.
NEVER
ALWAYS
cool down
DCL417
WARNING
BURN HAZARD
3
4
5
6
7
8
9
11
12
13
14
15
10