Filter
Top Products
PAGE 20 — GB114BS/BP GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #3 (01/06/09)
LOWERING THE EXTENSION POLE
Using the supplied 19 mm wrench, loosen extension 1.
clamp bolt (Figure 6-Q).
Carefully pull down on the adjustable extension pole 2.
(Figure 6-L) and lower lamp assembly.
Remove wingnut (Figure 6-D) from offset pole (Figure 3.
6B) and insert wrench into wrench holder. Reinsert
wingnut and tighten.
REMOVING LAMP ASSEMBLY
Disconnect balloon power cable (Figure 13) from the 1.
lamp power cable. Place lamp power cable in a safe
place where it will not get damage or lost..
Disconnecting Power CablesFigure 13.
NOTICE
Allow a suffi cient amount of time (15-20 minutes) for the
lamp to cool down . The possibility exists of the balloon
getting burned (touching the lamp).
BALLOON
POWER
CABLE
LAMP
POWER
CABLE
LAMP
ASSEMBL
Y
STORAGE
Remove both S-type hooks (Figure 9) on the lamp 2.
power cable from the cable support holes on the offset
pole.
Unzip the zipper on the protective cover (Figure 14), 3.
and pull down cover over balloon/lamp assembly.
Unzipping the Protective CoverFigure 14.
Fully zip protective cover and fold velcro tab in place.4.
Zipping the Protective CoverFigure 15.
Loosen T-handle bolt (Figure 6-O) by turning 5.
counterclockwise and remove lamp assembly (Figure
6-N) from offset pole.
Store lamp assembly enclosed within its protective 6.
cover (Figure 16) in a safe location where it will not be
damaged.
Storing Lamp AssemblyFigure 16.
PROTECTIVE
COVER
ZIPPER
VELCRO
TAB
PROTECTIVE
COVER
COVER/LAMP
CARRYING
CASE