Filter
Top Products
GB114BS/BP GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #3 (01/06/09) — PAGE 23
MAINTENANCE
FILTER REPLACEMENT
Remove the balloon as described in the "Removing 1.
the Lamp/Balloon" section.
Disconnect the lamp power cable (Figure 5).2.
Rotate the balloon/lamp base assembly so that the 3.
fi lter is facing upwards. See Figure 26.
Balloon/Lamp PlacementFigure 26.
Turn the three locking tabs (Figure 27) inward to 4.
release the plate. Remove plate and fi lter.
Filter Removal
Figure 27.
CAUTION
DO NOT replace fi lter immediately, allow
a suffi cient amount of time for the lamp
assembly to cool down before changing
fi lter
BALLOON/LAMP
PLATE
FILTER
LOCKING
TAB
TURN
OUTWARD
TO RELEASE
Install a new fi lter over the brace as shown in Figure 5.
28. Be sure to align the cut of the fi lter over the brace.
Filter Placement
Figure 28.
Turn the three retaining tabs (Figure 29) outward so 6.
that they touch the lamp base.
Filter/Plate Install
Figure 29.
BRACE
FILTER
CUT
CAUTION
When placing the fi lter element, always align the cut
of the fi lter on top of the brace. This will keep the fi lter
from being dislodged and getting damaged.
PLATE
FILTER
LOCKING
TAB
TURN
INWARD
TO LOCK