Filter
Top Products
GB114BS/BP GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #3 (01/06/09) — PAGE 25
MAINTENANCE
For a prolonged life cycle an extended quality follow the
recommended GloBug lighting system service guidelines
as referenced in Figure 30 and Table 4.
Periodic Check and MaintenanceTable 4.
Figure Part Check Item Solution Frequency
Lamp
L1 Lamp (Base) Lamp base loose? Screw in securely
❖
L2 Connector Cable disconnected or loose? Connect securely
❖
L3 Lamp Holder Lamp holder loose? Replace
❖
L4 Pipe Frame Frame pipe skewed? Replace
❖
L5 Lamp Defective lamp? Replace
■
Balloon
B1 Balloon (Envelope) Defective or dirty? Replace
❖
B2 Zipper Broken? Replace
❖
B3 Fan Motor (Blower) Not working properly? Repair or replace
❖
B4 T-Handle bolt (Balloon) Broken? Replace
❖
Electric
E1 Power Cable Defective or worn cable? Replace
❖
E2 Plug Damaged? Replace
❖
E3 Lamp Switch Damaged or not working properly? Replace
❖
Pole
P1 Clamp Broken? Repalce
❖
P2 Support pipe Support pipe bent or damaged? Replace
❖
P3 Support bolt Support bolt loose? Tighten securely
❖
P4 Straight pole Straight pole bent or damaged? Repalce
❖
P5 Offset pole Offset pole bent or damaged? Replace
❖
P6 Offselt bolt Offset bolt loose? Tighten securely
❖
❖ - Daily Check ■ - Every 20 Hours