Filter
Top Products
12 DS400 and DS500 Digital Fishfinders
5. Remove the mounting bracket knobs, bracket and mounting frame from
the unit. Make sure that the unit fits in the cut-out area.
6. Drill four 3/16 in (5 mm) holes as indicated on the template.
7. Hand tighten the studs into the holes provided at the rear of the unit.
8. Connect the Power/NMEA cable and transducer cables to the unit.
Avoid tight bends in the cables.
9. Place the gasket on the unit and slide the unit into the panel cut-out.
10. Hand tighten the nuts to secure the unit to the console.
11. Alternatively, place a spacer over each of the four studs and secure with
thumb nuts.
Figure 2-4: DS400/500 Flush Mounting Arrangement
D6631-1