Filter
Top Products
DS400 and DS500 Digital Fishfinders v
• Raymarine specified cables are used. Cutting and rejoining these cables
can compromise EMC performance and must be avoided unless doing so
is detailed in the installation manual.
• If a suppression ferrite is attached to a cable, this ferrite should not be
removed. If the ferrite needs to be removed during installation it must be
reassembled in the same position.
Safety Notices
1. PRODUCT INSTALLATION. This equipment must be installed and
operated in accordance with the instructions contained in this handbook.
Failure to do so could result in poor product performance, personal injury
and/or damage to your boat.
2. HIGH VOLTAGE. The display unit, transducer cable, and transducer
contain high voltages. Adjustments require specialized service procedures
and tools only available to qualified service technicians - there are no user
serviceable parts or adjustments.
3. NAVIGATION AID. This unit is only an aid to navigation. Its accuracy
can be affected by many factors, including equipment failure or defects,
environmental conditions, and improper handling or use. It is the user’s
responsibility to exercise common prudence and navigational judgments.
This fishfinder should not be relied upon as a substitute for such prudence
and judgment.
4. ULTRASONIC ENERGY. The transducer transmits high frequency
energy while in use. The unit should be turned off when swimmers or divers
are in close proximity to the transducer. (There is a lack of scientifically
sound standards or guidelines for exposure levels and limits to ultrasound.
This notice is precautionary only.)
WARNING:
Do not disconnect the transducer cable without first powering off the
display unit. Removal of the transducer cable from the DS400/500 while
power is turned on can cause sparks.
Mount unit where it is well ventilated and free from gasoline fumes.