Filter
Top Products
17
PWR
SETUP
PAGE
CLEAR
F
IS
H
F
IN
D
E
R
L265
Raymarine
4. Drill the two small holes for the threaded studs as shown on the
mounting template. Use a 7/32" (5.5 mm) drill bit.
5. Remove the template and draw straight lines between the 1/2" holes.
Cut along each of the lines with a small saw.
Fig. 2-11
Flush-mount
Installation
Screw holes
Fasten with
threaded studs
and wing nuts
Mounting hole
cut according to
template
Gasket
Installation
Fig. 2-12
Disassembling
from Bracket
To pry up the cap
insert a small
screwdriver here