Sony PCS-1 Marine Radio User Manual


 
2-4
PCS-1/1P
6. A line is not connected. (LAN)
. Check that the LAN cable is connected properly.
. Check that the left indicator (green) of the main units LAN connector blinks.
. Check that the LAN indicator (
) is highlighted in the system status display area (in the lower-right
position of the screen) of the initial screen.
. Check that an IP address is properly displayed below the LAN indicator.
. Check that the setting contents of a dial list and system setup are proper.
. Check that ping can be used for a default gateway or connection destination in the communication test
(Section 2-2) based on ping.
7. The voice from the remote side cannot be heard after line connection.
. Check that the volume of the main unit is proper.
. Check that the volume of a monitor is proper.
. Check that the audio cable of the main unit and monitor is connected properly.
. Check that the remote side is not set to MIC OFF.
. Check that the audio input on the remote side is proper. (Check that a voice is normally input using an
audio input level indicator on page 1/2 of an audio setup menu.)
8. A voice does not reach the remote side after line connection.
. Check that the volume of the main unit on the remote side is proper.
. Check that the volume of the monitor on the remote side is proper.
. Check that the audio cable of the main unit and monitor on the remote side is connected properly.
. Check that the local side is not set to MIC OFF.
. Check that the audio input on the local side is proper. (Check that a voice is normally input using an
audio input level indicator on page 1/2 of an audio setup menu.)
9. The image from the remote side is not displayed after line connection.
. Check that the video input on the remote side is selected properly.
. Check that the display can be switched using the remote/local button of a remote controller.
. Check that a local image is displayed in self-loopback (Section 2-1) without any problem.
. Check that a remote image is displayed during connection with other remote sides.
10. An image does not reach the remote side after line connection.
. Check that the video input on the local side is selected properly.
. Check that the display can be switched using the remote/local button of a remote controller on the
remote side.
. Check that a local image is displayed in self-loopback (Section 2-1) on the remote side without any
problem.
. Check that a remote image on the remote side is displayed during connection with other remote sides.