Sony PCS-1 Marine Radio User Manual


 
3-10
PCS-1/1P
2. Confirm that the IP address is displayed in the launcher menu of teleconference terminal B.
(Example: IP:192.100.20.20)
3. Confirm that Registration Confirm is displayed at the bottom of page 2 in the LAN setup menu of
teleconference terminal B.
4. The LAN setup menu of teleconference terminal A is set as described below.
DHCP Mode: ON
Host Name: Enter any name.
IP Address: Blank
Network Mask: Blank.
Gateway Address: Blank
DNS Address: Blank
Gatekeeper Mode: ON
Gatekeeper Address: 192.100.10.20
User Alias: Enter any name. (Example: PCS1A)
User Number: Enter any number. (Example: 100)
SNMP Mode: OFF
Trap Destination: Blank
Community: public
Description: Videoconference Device
Location: Blank
Contact: Blank
NAT Mode: OFF
NAT Address: Blank
Packet Resend Request: Blank
Adaptive Rate Control: OFF (Set to ON when a packet loss occurs frequently.)
LAN Mode: Auto Nagotiation (This mode is changed to a proper mode when mismatching
occurs in the mode. Refer to 4-2. PCS-1/1P and Hub setting.)
Port Number Used: Default (Set to Custom when a port number is specified by the network
administrator.)
TCP Port Number: 2253 (Enter the port number specified by the network administrator when
the port number used is set to Custom.)
UDP Port Number: 49152 (Enter the port number specified by the network administrator when
the port number used is set to Custom.)
TOS: OFF
PPPoE: OFF
PPPoE User Name: Blank
PPPoE Password: Blank
Fixed IP for PPPoE: OFF
Fixed IP Address for PPPoE: Blank
PPPoE DNS: Obtain automatically
Primary DNS: Cannot be set.
Secondary DNS: Cannot be set.
5. Confirm that the IP address is displayed in the launcher menu of teleconference terminal A.
(Example: IP:192.100.10.10)
6. Confirm that Registration Confirm is displayed at the bottom of page 2 in the LAN setup menu of
teleconference terminal A.
7. Enter LAN in the dial list of teleconference terminal A for a line I/F, user name PCS1B or user
number 200 of teleconference terminal B in it for an IP address, and other required items. After that,
register teleconference terminal B and initiate a call. Or set LAN for a line I/F and user name PCS1B
or user number 200 of teleconference terminal B for an IP address by Dial, and then initiate a call.