Filter
Top Products
3-3
PCS-1/1P
192.100.10.1 VPN 192.100.20.1
Teleconference
terminal A
192.100.10.10
Teleconference
terminal B
192.100.20.20
Router Router
LAN1 LAN2
3-2. Connection via Router
Example of system
When a call is initiated from teleconference terminal A to teleconference terminal B.
1. The LAN setup menu of teleconference terminal B is set as described below.
DHCP Mode: OFF
Host Name: Enter any name.
IP Address: Local IP address (192.100.20.20)
Network Mask: Depends on a network. Usually, set to 255.255.255.0.
Gateway Address: 192.100.20.1
DNS Address: Blank
Gatekeeper Mode: OFF
Gatekeeper Address: Blank
User Alias: Blank
User Number: Blank
SNMP Mode: OFF
Trap Destination: Blank
Community: public
Description: Videoconference Device
Location: Blank
Contact: Blank
NAT Mode: OFF
NAT Address: Blank
Packet Resend Request: Blank
Adaptive Rate Control: OFF (Set to ON when a packet loss occurs frequently.)
LAN Mode: Auto Nagotiation (This mode is changed to a proper mode when mismatching
occurs in the mode. Refer to “4-2. PCS-1/1P and Hub setting”.)
Port Number Used: Default (Set to “Custom” when a port number is specified by the network
administrator.)
TCP Port Number: 2253 (Enter the port number specified by the network administrator when
the port number used is set to “Custom”.)
UDP Port Number: 49152 (Enter the port number specified by the network administrator when
the port number used is set to “Custom”.)
TOS: OFF
PPPoE: OFF
PPPoE User Name: Blank
PPPoE Password: Blank
Fixed IP for PPPoE: OFF
Fixed IP Address for PPPoE: Blank