Sony PCS-1 Marine Radio User Manual


 
4-3
PCS-1/1P
4-2. Setting of PCS-1/1P and HUB
The initial setting of the PCS-1/1P is Auto.
In the Auto setting of the PCS-1/1P, 10/100 can be selected automatically, however, Half/Full cannot be selected
automatically. Therefore, if the HUB is set to Full mode, a connection failure or packet loss occurs. The following table
shows an example of connection between the PCS-1/1P and Catalyst 2950. When the HUB is set to 100FULL or 10FULL,
change the setting of HUB or adjust the PCS-1/1P setting to HUB. Refer to Operating Instructions.
Table of connection between PCS-1/1P and Catalyst 2950
PCS-1/1P setting AUTO 100FULL 100HALF 10FULL 10HALF
2950 setting
AUTO OK Packet loss OK Packet loss OK
100FULL Packet loss OK Packet loss Connection failure Connection failure
100HALF OK Packet loss OK Connection failure Connection failure
10FULL Packet loss Connection failure Connection failure OK Packet loss
10HALF OK Connection failure Connection failure Packet loss OK
4-3. Audio and Video Input/Output Characteristics
4-3-1. Audio input/output characteristics of PCS-1/1P
Name Connector Impedance Input/output level Remarks
MIC1/MIC2 (Input) Mini-jack 4.7 kZ (Plug in power) The reference value of an input level is _55 dBs.
AUDIO IN (Input) Pin jack 47 kZ or higher, Unbalanced The reference value of an input level is _9 dBs.
AUDIO OUT (Output) Pin jack 1 kZ or less, Unbalanced Reference value _12 dBs
AUDIO OUT (MIXED) Pin jack 1 kZ or less, Unbalanced Reference value _12 dBs
(Output)
4-3-2. Video input/output characteristics of PCS-1/1P
Name Connector Specifications Remarks
VIDEO IN AUX1 (Input) Mini DIN 4-pin S video input signal PCS-1: NTSC
Y signal: 0.7 V p-p/75 Z PCS-1P: PAL
C signal: 0.3 V p-p/75 Z
VIDEO IN AUX2 (Input) Pin jack Composite input signal PCS-1: NTSC
1 V p-p/75 Z PCS-1P: PAL
VIDEO OUT AUX (Output) Pin jack Composite output signal PCS-1: NTSC
1 V p-p/75 Z PCS-1P: PAL
VIDEO OUT MONITOR MAIN (Output) Mini DIN 4-pin S video output signal PCS-1: NTSC
Y signal: 0.7 V p-p/75 Z PCS-1P: PAL
C signal: 0.3 V p-p/75 Z
VIDEO OUT MONITOR SUB (Output) Mini DIN 4-pin S video output signal PCS-1: NTSC
Y signal: 0.7 V p-p/75 Z PCS-1P: PAL
C signal: 0.3 V p-p/75 Z
RGB OUT (Output) D-Sub 15-pin RGB video output
(H/V/R/G/B: 0.7 V p-p/75 Z)