Filter
Top Products
Radar Operation Manual Page 31
Handling of Center Offset
If the Radar is in Relative Motion mode, positioning the Cursor on the center of the Radar
image, allows editing the Center Offset (“CTR” message is shown under the cursor
position). The Soft Keys are automatically displayed
(EXCEPT CP180/CP180i)*:
[MOVE] When selected allowing the ShuttlePoint knob to move it at any location on the Radar screen
[ENTER] Confirms the new position of the center.
[CLEAR] Resets the position of the Radar image at 0,0.
[O
FFSET] Opens an edit window where it is possible to edit the X Offset and Y Offset position in pixel at which
the center of the screen is positioned.
NOTE for CP180/CP180i*
Pressing [ENT] opens an Options window with MOVE, ENTER, CLEAR and OFFSET items, move
the ShuttlePoint knob to highlight what you want and press [ENT] to select.
To use the Radar menu to set the Center Offset follow the procedure:
1. Press [MENU]. Move the ShuttlePoint knob to highlight
FEATURES and press [ENT].
2. Move the ShuttlePoint knob to highlight
CENTER OFFSET and press [ENT].
3. Move the ShuttlePoint knob to highlight the desired choice and press [ENT].
4.3.4 User Points
AVAILABLE ONLY IN THE RADAR FULL PAGES
It is possible to show the Marks and Waypoints in a Route on the Full Radar pages: when
the Cursor is moved over top of icon, Mark information window appears.
N
E
W
S
Figure 4.3.4 - Marks display on Full Radar page
To turn the Marks display On or Off, follow this procedure:
1. Press [MENU]. Move the ShuttlePoint knob to highlight
FEATURES and press [ENT].
2. Move the ShuttlePoint knob to highlight
USER POINTS and press [ENT].
3. Move the ShuttlePoint knob to highlight
ON or OFF and press [ENT].
4.3.5 AIS Targets
AVAILABLE ONLY IN THE RADAR FULL PAGES
It is possible to show the AIS Targets on the Full Radar pages: when the Cursor is moved
over top of icon, a AIS popup window appears.
NOTE
This function is only available when a optional AIS receiver is connected to the Chart Plotter.