Standard Horizon CP300 Marine RADAR User Manual


 
Radar Operation Manual Page 7
1. INTRODUCTION
1.0 CONVENTIONS USED
Please refer to the legend below:
[MENU] If you see brackets around a bold and capital letter word this refers to a key press.
[CHART] If you see brackets around a bold and small capital letter word this refers to a Soft Key
press.
GENERAL SETUP When a word(s) is in bold capital letters and underlined, this refers to a menu selection
item.
1.1 INTRODUCTION
Any menu operation and functions activation in this Operation Manual is related to the
following Chart Plotter models with software capable to operate a Radar Antenna.
Whenever it is necessary, a note has been inserted for those models with operational
differences.
· CP180
· CP180i
· CP300
· CP300i
· CPV350
· CP500
· CPV550
To confirm the Chart Plotter has the software to operate a Radar Antenna:
1. Turn on the Chart Plotter, select the chart page.
2. Press [MENU] and look for a Radar selection.
If the Chart Plotter has a Radar selection, it has the software. If the Chart Plotter does not
have the software, it is available by contacting Standard Horizon Marine Product Support
at 800/767-2450 (USA) or Standard Horizon/Vertex Standard authorized dealers (outside
the US and Canada) for a Software Card. Refer Si-Tex Installation Manual for software
update procedure.
1.2 GENERAL INFORMATION
PRODUCT SUPPORT INQUIRIES
If you have any questions or comments, we invite you to visit www.standardhorizon.com to
send an E-Mail or contact the Product Support team at 800-767-2450 M-F 7:00-5:00PST
(in USA or Canada) or Standard Horizon/Vertex Standard authorized dealers (Outside USA
or Canada).