Filter
Top Products
112 En
Advanced setup
■ SIRIUS Satellite Radio Parental Lock
personal identification number reset
SR PIN
Use this feature to set the code number (personal
identification number) for the SIRIUS Satellite Radio
Parental Lock feature to the initial factory setting. This
feature is useful when you forget or want to change the
current code number.
Choices: RESET, CANCEL
• Select “RESET” to set the code number to the initial
factory setting.
• Select “CANCEL” to set the code number to the initial
factory setting.
Even if you set “SR PIN” to “RESET”, this unit does not unlock
the locked channels. The initial factory setting of the Parental
Lock code number is “0000”.
■ Bi-amplifier setting BI-AMP
Use this feature to activate or deactivate the bi-amplifier
function (see page 16).
Choices: ON, OFF
• Select “ON” if you want to activate the bi-amplifier
function. “SUR.B L/R SP” is set to “NONE”
automatically, and this unit outputs the front channel
audio signals at the SURROUND BACK/BI-AMP
speaker terminals.
• Select “OFF” if you want to deactivate the bi-amplifier
function.
When “BI-AMP” is set to “ON”, you can only select “FRONT
B”, “ZONE B”, or “NONE” in “EXTRA SP ASSIGN” (see
page 87).
■ SCENE IR code setting SCENE IR
Use this feature to output the remote control signals at the
REMOTE OUT jack automatically when this unit is in the
SCENE mode.
Choices: ON, OFF
• Select “ON” when the component connected to the
REMOTE OUT jack is the Yamaha component and has
the capability of the SCENE control signals. This unit
automatically sends the remote control signals to the
component.
• Select “OFF” when the component connected to the
REMOTE OUT jack is not the Yamaha component and
does not have the capability of the SCENE control
signals.
If noises are output when you operate the SCENE function, set
“SCENE IR” to “OFF”.
■ Monitor check MON.CHK
Use this feature to activate or deactivate the monitor check
function of this unit. When “MON. CHK” is set to “YES”,
this unit receives the information of the available video
signal resolutions from the video monitor connected via
HDMI and you can only select the resolutions supported
by the video monitor in “HDMI RES.” (see page 99).
When “MON. CHK” is set to “SKIP”, you can select any
resolution in “HDMI RES.”.
Choices: YES, SKIP
■ Tuner frequency step TU
(Asia and General models only)
Use this feature to set the tuner frequency step according
to the frequency spacing in your area.
Choices: AM10/FM100, AM9/FM50
• Select “AM10/FM100” for North, Central and South
America.
• Select “AM9/FM50” for all other areas.
■ Parameter initialization INIT
Use this feature to reset the parameters of this unit to the
initial factory settings. You can select the category of
parameters to be initialized.
Choices: DSP PARAM, VIDEO, ALL, CANCEL
• Select “DSP PARAM” to initialize all the parameters
of the sound field programs (see page 74).
• Select “VIDEO” to initialize the parameters in
“VIDEO SET” (see page 98) and “OSD SHIFT” in
“DISPLAY SET” (see page 98).
• Select “ALL” to initialize all the parameters of this
unit.
• Select “CANCEL” to cancel the initialization
procedure.
Use “INITIALIZE” in the sound field program menu to initialize
the parameters of the desired program (see page 74).
See page 109 for the operation of the advanced setup.
Note
Note
Note
Note