Filter
Top Products
66 En
SIRIUS Satellite Radio™ tuning
■ All Channel Search mode
1 Press
B
SEARCH MODE (or
I
SRCH
MODE) repeatedly to select “ALL CH
SEARCH”.
2 Press
E
PRESET/TUNING/CH l / h (or
8
PRESET/CH k / n) repeatedly to search
for a channel within all channels.
y
• You can search for a channel quickly by pressing and holding
E
PRESET/TUNING/CH
l
/
h
(or
8
PRESET/CH
k
/
n
).
• You can skip channels to the previous or next category by
pressing
D
CATEGORY (or
8
A-E/CAT. l / h).
■ Category Search mode
1 Press
B
SEARCH MODE (or
I
SRCH
MODE) repeatedly to select “CAT SEARCH”.
2 Press
D
CATEGORY (or
8
A-E/CAT. l / h)
repeatedly to change the channel category.
3 Press
E
PRESET/TUNING/CH l / h (or
8
PRESET/CH k / n) repeatedly to search
for a channel within the selected channel
category.
y
You can search for a channel quickly by pressing and holding
E
PRESET/TUNING/CH l / h (or
8
PRESET/CH k / n).
This unit skips the channels when this unit is All Channel Search
mode or Category Search mode in the following cases (it is not
malfunction of this unit):
– the channel is locked (see page 67).
– the channel is out of service.
– you do not subscribe to the channel.
■ Preset Search mode
Prior to selecting a preset channel in the Preset Search
mode, you must preset SIRIUS channels. For details, see
“Setting the SIRIUS Satellite Radio™ preset channels” on
page 67.
1 Press
B
SEARCH MODE (or
I
SRCH
MODE) repeatedly to select “PRESET
SEARCH”.
2 Press
D
CATEGORY (or
8
A-E/CAT. l / h)
repeatedly to change the preset channel
group (A to E).
3 Press
E
PRESET/TUNING/CH l / h (or
8
PRESET/CH k / n) repeatedly to change
the preset channel number (1 to 8).
y
You can also select the preset channel number directly by
pressing the numeric buttons (1 to 8) (
6
).
■ Direct number access mode
1 Press
I
SRCH MODE on the remote control
repeatedly to select “ALL CH SEARCH” or
“CAT SEARCH”.
2 Press the numeric buttons (
6
) to enter the
desired three-digit channel number.
For example, to enter the number 123, press the
numeric buttons (
6
) as shown below.
y
• To display the Sirius ID number displayed in the front panel
display, select channel “0”.
• To enter a one-digit or two-digit channel number, press the
numeric buttons (
6
) on the remote control and then press
H
ENT to confirm the input number.
• Instead of pressing
H
ENT to tune into the channel
immediately, you can wait a few seconds until this unit
confirms the entered channel number.
• If no button is pressed within a few seconds after you enter a
one-digit or two-digit number, this unit automatically confirms
the entered channel number.
• If the selected channel is locked, “PIN:___” appears in the front
panel display. Enter the four-digit Parental Lock code number
by using the numeric buttons (
6
) or press
H
ENT to cancel
(see page 67).
Before performing the following operations, set the operation
mode selector on the remote control to
F
SOURCE and then
press
4
SIRIUS.
Note
1
2
3