Filter
Top Products
61 En
XM Satellite Radio tuning
BASIC
OPERATION
English
■ All Channel Search mode
1 Press
B
SEARCH MODE (or
I
SRCH
MODE) repeatedly to select “ALL CH
SEARCH”.
2 Press
E
PRESET/TUNING/CH l / h (or
8
PRESET/CH k / n) repeatedly to search
for a channel within all channels.
y
• You can search for a channel quickly by pressing and holding
E
PRESET/TUNING/CH l / h (or
8
PRESET/CH k / n).
• To display the XM Radio ID number displayed in the front
panel display, select channel “0”.
■ Category Search mode
1 Press
B
SEARCH MODE (or
I
SRCH
MODE) repeatedly to select “CAT SEARCH”.
2 Press
D
CATEGORY (or
8
A-E/CAT. l / h)
repeatedly to change the channel category.
3 Press
E
PRESET/TUNING/CH l / h (or
8
PRESET/CH k / n) repeatedly to search
for a channel within the selected channel
category.
y
You can search for a channel quickly by pressing and holding
E
PRESET/TUNING/CH l / h (or
8
PRESET/CH k / n).
■ Preset Search mode
Prior to selecting a preset channel in the Preset Search
mode, you must preset XM Satellite Radio channels. For
details, see “Setting the XM Satellite Radio preset
channels” on page 62.
y
The initial factory setting of all preset channels (A1 to E8) is “001
Preview”.
1 Press
B
SEARCH MODE (or
I
SRCH
MODE) repeatedly to select “PRESET
SEARCH”.
2 Press
D
CATEGORY (or
8
A-E/CAT. l / h)
repeatedly to change the preset channel
group (A to E).
3 Press
E
PRESET/TUNING/CH l / h (or
8
PRESET/CH k / n) repeatedly to change
the preset channel number (1 to 8).
y
You can also select the preset channel number directly by
pressing the numeric buttons (1 to 8) (
6
).
■ Direct number access mode
1 Press
I
SRCH MODE on the remote control
repeatedly to select “ALL CH SEARCH” or
“CAT SEARCH”.
2 Press the numeric buttons (
6
) to enter the
desired three-digit channel number.
For example, to enter the number 123, press the
numeric buttons (
6
) as shown below.
y
• To enter a one-digit or two-digit channel number, press the
numeric buttons (
6
) on the remote control and then press
H
ENT to confirm the input number.
• Instead of pressing
H
ENT to tune into the channel
immediately, you can wait a few seconds until this unit
confirms the entered channel number.
• Pressing a button other than the numeric buttons (
6
) or
H
ENT
cancels the Direct Number Access mode procedure.
Before performing the following operations, set the operation
mode selector on the remote control to
F
SOURCE and then
press
4
XM.
1
2
3