Filter
Top Products
Control function operation
32
TY” indicator light blinks two or three times,
then comes on. This indicates the unlock
mode is selected.
EJU31152
Engine stop switch “ ”
The engine stop switch (red button) stops the
engine when the switch is pushed.
EJU31163
Engine shut-off switch “ ”
The engine shut-off switch automatically
stops the engine when the clip, on the end of
the engine shut-off cord (lanyard), is removed
from the switch, such as if the operator falls off
the watercraft.
Insert the clip under the engine shut-off switch
before starting the engine.
When the engine is not running, remove the
clip from the engine shut-off switch to prevent
accidental starting or unauthorized operation
by children or others.
EJU41650
Start switch “ ”
NOTICE
ECJ01310
Do not run the engine over 4000 r/min on
land. Also, do not run the engine for more
than 15 seconds without supplying water,
otherwise the engine could overheat.
The start switch (green button) starts the en-
gine when the switch is pushed.
Release the start switch as soon as the en-
gine starts to run. If the engine does not start
1 “L-Mode” (unlock) button
2 “SECURITY” indicator light
1 Engine stop switch
2
L-Mode
1
1
1 Engine shut-off switch
2 Clip
3 Engine shut-off cord (lanyard)
STOP
3
1
2
chapter4 Page 32 Friday, October 9, 2009 2:37 PM