Installing Additional Components
PCI Card Installation
Chapter 3
33
CAUTION Observe all ESD safety precautions while performing this procedure. Failure to
follow ESD safety precautions could result in damage to the server.
Step 3. If a cable will block card removal, or if it is connected to the card to be removed, disconnect the
cable(s) from card connector(s) at this time.
Step 4. Using an ACX-15 torx screwdriver, remove the retaining screw that secures the card in place. See
Figure 3-12.
Figure 3-12PCI Card Retaining Screws
Step 5. Grasp the card by the two opposing edgers and lift the card from the socket.
Step 6. If no card will be installed in the empty socket, install a blank panel in the bulkhead opening at the
end of the card cage. The blank panel is necessary to ensure correct air flow and EMI protection
when the card cage is installed in a working server.
Installing a PCI Card
NOTE The PCI card cage must be removed from the server chassis to allow installation of PCI cards.
The four connectors in the PCI card cage are identical and have the same capabilities. A compatible PCI card
may be installed in any slot. To install a PCI card, perform the following steps:
Step 1. Remove the PCI card cage from the server chassis. Refer to “Removing the PCI Card Cage
Assembly” on page 31.
pciccscrw2
Card
Retaining
Screws
