Cable Connections
Core I/O Connections
Chapter 5
73
NOTE The value in the “IP address” field is set at the factory. The customer must provide
the actual management processor LAN IP address.
Step 3. The current lc data is displayed. When prompted to enter a parameter name, A to modify All, or
Q to Quit, enter A to select all parameters.
Step 4. The current IP address is displayed. When prompted to enter a new value or Q, enter the new IP
address.
Step 5. The current host name is displayed. When prompted to enter a new value or Q, enter the new
management processor network name.
This is the host name for the management processor LAN. The name can be up to 64 characters in
length, and can include dashes, underlines, periods and spaces.
Step 6. The current subnet mask name is displayed. When prompted to enter a new value or Q, enter the
new subnet mask name.
Step 7. The current gateway address is displayed. When prompted to enter a new value or Q, enter new the
gateway address.
Step 8. The current web console port number is displayed. When prompted to enter a new value or Q, just
hit
enter. The message -> Current Web Console Port Number has been retained will be
displayed.
Step 9. The current link state information is displayed. When prompted to enter a new value or Q, just
press
enter. The message -> Current Link State has been retained will be displayed.
Step 10. A new lc listing is displayed, including the values entered in the preceding steps. Verify that the
desired values have been accepted. When prompted to enter a parameter for revision, Y to confirm,
or Q to Quit, enter Y to confirm all parameters.
Step 11. Observe the following display:
> LAN Configuration has been updated
-> Reset MP (XD command option ‘R’) for configuration to take effect.
MP Host Name: name (the name entered in step 5)
MP:CM>
Step 12. Enter XD -reset to reset the MP.
Step 13. After the MP resets, log into the MP again. Then enter the MP command mode (enter CM at the MP:
prompt).
Step 14. At the MP:CM> prompt, enter LS to confirm the new LAN settings.
Step 15. Enter SA to enable/disable web console and telnet access after the MP has been reset.
