72 Wavelink Avalanche Enabler Configuration
RX2 Reference Guide E-EQ-RX2RG-B
Scan Config Note: LXE does not support the Scan Configuration feature on Windows CE
devices.
The Scan Config option under the File menu allows the user to configure
Enabler settings using a special barcode that can be created using the
Avalanche Management Console utilities. Refer to the Wavelink Avalanche
Manager User Guide for details.
Exit The Exit option is password protected. The default password is leave. The
password is not case-sensitive.
If changes were made on the Startup/Shutdown tab screen, then after entering
the password, tap OK and the following screen is displayed:
Change the option if desired. Tap the X button to cancel Exit. Tap the OK
button to exit the Avalanche applet.
Avalanche Update Settings
Access: Start | Avalanche | File | Settings
Use these menu options to setup the Avalanche Enabler on the mobile device. LXE recommends
changing and then saving the changes (reboot) before connecting to the network.
Alternatively, the Agent on the Wavelink Avalanche Management Console can be disabled until
needed (refer to the Wavelink Avalanche Manager User Guide for details).
Menu Options
Settings Tab Function
Connection
Enter the IP Address or host name of the Agent portion of the
Avalanche Management Console. Set the order in which serial ports or
RF are used to check for the presence of the Agent.
Execution Unavailable in this release.
Server Contact
Setup synchronization, scheduled Agent contact, suspend and reboot
settings.
Startup/Shutdown Set options for Enabler program startup or shutdown.
