5. BASE SPECIFICATIONS PARAMETERS
II - 46
(SETUP PARAM 1. 6/16)
# Items Details Setting range (unit)
1169 system
name
Not used.
1170 M2name Second
miscellane-
ous code
Set this address code when using the 2nd
miscellaneous command. Set an address with A‚ B
and C that is not used with #1013 axname or #1014
incax.
A, B, C
1171 taprov Tap return
override
Set the tap return override value for the synchronous
tap.
1 to 100 (%)
1172 tapovr Tap return
override
Set the override value when leaving the tap end point
in the synchronous tap cycle.
The setting range is 1 to 999‚ and the unit is %.
When a value less than 100 is set‚ it will be judged as
100%.
1 to 999 (%)
1173 dwlskp G04 skip
condition
Specify the skip signal for ending the G04 (dwell)
command.
Skip condition 0 to 7
0
1
2
3
4
5
6
7
Skip 1
Skip 2Skip 3
Set-
ting
PLC interface input signal
End when { signal is
input.
1174 skip_F G31 skip
speed
Specify the feedrate when there is no F command in
the program at G31 (skip) command.
1 to 999999 (mm/min)
1175
1176
1177
1178
1179
1180
skip1
1f
2
2f
3
3f
G31.1 skip
condition
G31.2 skip
speed
G31.2 skip
condition
G31.2 skip
speed
G31.3 skip
condition
G31.3 skip
speed
Specify the skip signal in the G31.1 to G31.3
(multi-step skip) command‚ and the feedrate when
there is no F command in the program.
Skip signal specified at G31.1
Skip feedrate at G31.1
Skip signal specified at G31.2
Skip feedrate at G31.2
Skip signal specified at G31.3
Skip feedrate at G31.3
Skip condition 0 to 7
0
1
2
3
4
5
6
7
Skip 1
Skip 2Skip 3
Set-
ting
PLC interface input signal
Skip feedrate
1 to 999999 (mm/min)
