5. BASE SPECIFICATIONS PARAMETERS
II - 50
# Items Details Setting range (unit)
1209 cirdcc Arc
decelerati
on speed
Specify the deceleration speed at the arc entrance or
exit.
1 to 999999 (mm/min)
1210 RstGmd Modal G
code reset
Specify whether to initialize each G code group modal
and the H and D codes when the system is reset.
Specify the initialization items in bit correspondence.
0. Initialize. 1: Don't initialize.
M system
Specify a hexadecimal
number.
The H code indicates the tool length offset number, and
the D code indicates the tool radius compensation
number.
When bit 18 is set to ON, the H and D codes and group
8 G modal area retained.
When bit 7 is set to ON, the H code and group 8 G
modal are retained.
(To be continued to the next page)
10 Group 17 Constant surface speed control command modal
11 Group 18 pole coordinate command modal
12 Group 19 G command mirror modal
13 Group 20 Spindle 2 control modal
14
15
16
17
18 H, D codes
19 Spindle clamp rotation speed
1A
1B
1C
1D
1E
1F
0 Group 1 Move G modal
1 Group 2 Flat selection modal
2 Group 3 Absolute/increment command modal
3
4 Group 5 Feed G modal
5 Group 6 Inch/metric modal
6 Group 7 Radius compensation modal
7 Group 8 Length compensation modal
8
9 Group 10 Fixed cycle return command modal
A
B Group 12 Workpiece coordinate system modal
C Group 13 Cut modal
D
E System reserve
F
