2. OPERATION MESSAGES ON SETTING AND DISPLAY UNIT
2.1 Operation Errors
I - 47
Error No. Error message Details
E07 RESET END
∆
• The input/output operations were forcibly stopped by reset‚ etc.
(including EMG).
E08 PHYSICAL ERR
×
• The input/output parameter setting or input/output unit side
setting was incorrect.
E09 TIME OUT
×
• The input/output unit parameter "#9116 TIME-OUT SET" setting
was too short.
• There is no EOB code in the machining program.
E10 MEMORY OVER
×
• The program cannot be written because the memory capacity is
exceeded.
• This error occurs when the MDI data setting on the MDI screen
exceeds 500 characters‚ or when saving MDl‚ editing or making a
program on the edit screen‚ input on the data input/output
screen‚ program copy‚ etc.
E11 PROG. No. DUPLI
∆
• When registering a machining program in the memory‚ a
program with the same No. as the designated program No. was
found in the memory. Refer to the program file to find a program
No. not being used‚ and reset the program No.
• A program with the same No. as the machining program to be
copied from the memory was found in the IC card.
• This error occurs during MDI registration in the MDI screen or
during creation of a program in the edit screen.
E12 FILE ENTRY
OVER
×
• When registering a machining program in the memory‚ the No. of
programs determined in the specifications is exceeded‚
preventing registration.
This error occurs during MDI registration in the MDI screen‚
creation of a program in the edit screen‚ data input in the data
input/output screen‚ and program copy.
E13 NB NOT FOUND
∆
• The block with the designated sequence No. or block No. does
not exist in the designated program.
E14 PROG. NOT
FOUND
∆
• The designated program is not found in the memory.
• A machining program in the IC card was searched during
emergency stop.
• The corresponding program No. was not found with operation
search in the tape or memory operation mode during graphic
check.
E15 EDIT LOCK B
×
• An operation (edit‚ input/output‚ buffer correction‚ etc.) inhibited
for machining program B was attempted.
E16 EDIT LOCK C
×
• An operation (edit‚ input/output‚ buffer correction‚ etc.) inhibited
for machining program C was attempted.
E17 PARITY H ERR
×
• A parity H error was detected during data input‚ etc.
• Check the paper tape or input device. This error may occur if the
paper tape is dirtied with oil‚ etc.
E18 PARITY V ERR
×
• A parity V error was detected during data input.
• Check the paper tape to see whether the number of characters in
the significant information section of a block is odd.
• Also check the state (cable wiring‚ noise measures‚ etc.) of the
connected equipment.
